Where’s the job?

Overview

• Installing door stripping systems to enhance insulation, reduce draughts and improve energy efficiency.

• Skill level: 2 / 5 (basic measuring, cutting and fitting required).

• Typical duration: 2 – 4 hours depending on door size and type.

Safety First

• Always use a sharp utility knife carefully – ensure blades are properly secured to prevent accidental injury.

• Wear protective gloves and eye safety gear when handling cutting tools and adhesives.

• Secure the door properly on stands to avoid stress on the doorpanes during work.

• Ensure adequate ventilation when using strong adhesives or solvents.

Tools & Materials

Step-by-Step

1. Measure the door perimeter carefully and note any irregularities.

2. Remove old stripping and clean the door frame for a secure fit.

3. Cut the new stripping to match each section of the door edge.

4. Apply adhesive or fixings and press the stripping firmly into place.

5. Check the alignment and adjust if necessary to ensure a tight seal.

6. Allow any adhesive to cure fully before regular door use.

Completion Checks

• The stripping should lie flush with the door frame, leaving no visible gaps.

• Adhesive or fixings must be secure and the finish neat.

• The door should close easily and maintain optimal insulation.

When to Call a Pro Instead

If door stripping is needed for heritage properties, unusually designed doors or when previous damage affects performance, consult a door repair specialist to ensure proper installation and longevity.